120mm (4.75") PVC Heat Shrink Wrap For Battery Packs - 10 Foot Roll

$15.99
(No reviews yet) Write a Review
SKU:
SW_120_10

Out of stock

PVC Heat Shrink Wrap Tube
Size 120mm (4.75")

10 foot roll

****Warning****

Use at your own risk.  Buyer assumes all responsibility for any injuries and damages resulting from any use of this item.

  • The shrink wrap is for covering your custom battery packs!
  • To find the size you need, measure the widest cross-section circumference of your pack and then divide it by 2. Use the shrink wrap size at least 5 mm (1/5 inch) wider than your half circumference value.
  • Use hair dryer evenly heat up the wrap to shrink until it is tightly wrapped around the battery pack.
  • It's 5 mils ( 1 mil = 0.001 inch) thick with a 2:1 shrink ratio.
  • Shrinking rate: cross section: 48% +/-5; longitudinal: 15% +/-3 (measure in boiling water for 1 minute)
  • Thickness: 0.005 inch
  • Width: 4.75" (120mm)
  • Length: 10' (120")

 

Colors may vary from picture.  Typical colors are black, blue, green and/or red.  We will ship what is in stock at the time of your purchase.