PVC Heat Shrink Wrap Tube
Size 210mm (8.26")
10 foot roll
Use at your own risk. Buyer assumes all responsibility for any injuries and damages resulting from any use of this item.
- The shrink wrap is for covering your custom battery packs!
- To find the size you need, measure the widest cross-section circumference of your pack and then divide it by 2. Use the shrink wrap size at least 5 mm (1/5 inch) wider than your half circumference value.
- Use hair dryer evenly heat up the wrap to shrink until it is tightly wrapped around the battery pack.
- It's 5 mils ( 1 mil = 0.001 inch) thick with a 2:1 shrink ratio.
- Shrinking rate: cross section: 48% +/-5; longitudinal: 15% +/-3 (measure in boiling water for 1 minute)
- Thickness: 0.005 inch
- Width: 8.65" (210mm)
- Length: 10' (120")
Colors may vary from picture. Typical colors are black, blue, green and/or red. We will ship what is in stock at the time of your purchase.