64mm (2.52") PVC Heat Shrink Wrap For Battery Packs 10 foot roll - US Seller
Out of Stock
PVC Heat Shrink Wrap Tube Size 64mm (2.52")
10 foot roll
Use at your own risk. Buyer assumes all responsibility for any injuries and damages resulting from any use of this item.
The shrink wrap is for covering your custom battery packs!
Use for parallel configuration of all small batteries, such as 2/3A, A, AA, AUP, FAUP, etc.
Use for 2 cell 18650 pack as well.
To find the size you need, measure the widest cross-section
circumference of your pack and then divide it by 2. Use the shrink wrap
size at least 5 mm (1/5 inch) wider than your half circumference value.
Use a hair dryer to evenly heat up the wrap to shrink until it is tightly wrapped around the battery pack.
It's 5 mils ( 1 mil = 0.001 inch) thick with a 2:1 shrink ratio.
Shrinking rate: cross section: 48% +/-5; longitudinal: 15% +/-3 (measure in boiling water for 1 minute)
Thickness: 0.005 inch
U.S.A - free standard shipping Expedited options are available.
RETURNS AND EXCHANGES
Return this item within 14 days for a full refund or exchange.
Only unmodified and unwrapped items will be accepted as a return.
with or modifying this item in any way without prior written approval
from seller will void any applied warranty, no returns will be accepted! Contact us for any other return and exchange questions.
Please contact us if you need a custom made battery pack that is not listed in stock.